Running a program causes camera movement

Robot Mesh Studio
#1

Hi there! I am just testing out this program to use for an online robotics class, however when I use the V5 mimic program and I run a very simple program - with one motor, a shaft and gear all attached, and one block moving motor 1 forward - every time I press “run” or “test program” the camera flies up what I think is the z-axis and nothing seems to move.

I’m not sure what is causing this or how to stop it, or perhaps I am using the program incorrectly? I’d appreciate some insight! I’m on a Mac using Chrome if that matters.

Thanks!

1 Like
#2

Hi Agnapot.

Could you set your program to Public, Including Code and link to it?

Cheers, Sam

1 Like
#3

Thanks, but I think I figured it out. I had no Arena set, so what was actually happening was that everything was falling down due to gravity, which I didn’t know existed. =P Powerful simulator, if you know the details of how it works!

1 Like